AnsweredAssumed Answered

Making a correct thread with thread location and end conditions / offsets

Question asked by Ryan Freker on Feb 26, 2019
Latest reply on Feb 26, 2019 by M. B.

I have a thread of M12x1.75 that is on a radius of 10.25. In the past I would have the thread just have an offset so that it has the less crude thread location and end condition. But, in this case, I have a different radius on this part that if I was to have an offset, it still doesn't look right. Ideas on what I should do to make it look correct or if my original problem is even a problem or not? I have attached an image of what I am talking about.

Attachments

Outcomes