I have a structural member that I have created under weldments and I now need to cut it at 45 degrees on one end. What is the best way to do this? Thanks in advance
Create a plane, and use trim tool from weldment toolbar.
Or create a sketch at the end and extrude cut.
I'd advise a simple Extruded Cut.
I personally always use the trim to plane method but was curious if the extrude cut would show correctly in the cut list. Looks like both methods work and its just a matter of preference.
Thanks Guys. I created a plan and then used the trim/extend command. I will also give the extrude cut a go. As you no doubt realise, I'm new to all this so I'm keen to get as much knowledge and experience as I can. Thanks again.
You can also use Move Face and use the rotate option
Retrieving data ...