AnsweredAssumed Answered

Help with Strange Shapes Appearing in Assemblies

Question asked by Barrett Pearce on Feb 22, 2019
Latest reply on Feb 22, 2019 by Newell Voss

Sorry if this has been covered already, but I searched fairly well and didn't find anything. A large assembly I'm working on has been showing me these artifacts, and I'm not really sure what's causing it, or how to get rid of them. It usually starts small, and gets worse as I manipulate the model around. Check out the image below.

 

 

Some things I've done to remedy this:

- If one of these shoots off of an obvious location, I can suppress, delete, or reload that component

It is rarely obvious, so this isn't a great option

I've gone as far as checking everything in, and reloading the upper level - this did not work

- Close everything, restart the PC, reopen the file

Very disruptive, but works every time, for about a day

- Set lightweight to resolved

This worked once, and never again after that - could have been a fluke

 

Thanks for the help

Outcomes