How to get this dimension (Sketch inside assembly) in Rule Builder?
You can't get dimension in rule builder.
To drive dimension you need to capture dimension and then build rule to drive value.
So I could link it in file properties(custom properties) under a name for example to make this happen? I hope I understood that correctly.
Yes, you can link dimension in custom property. If you want's to shown in note you can link property in note.
So what do you think. What would be the best option in this case? Linking in custom properties or something else?
I've noticed you've had a few posts recently in the forum regarding DriveWorksXpress, you might want to sign up the DriveWorksXpress Getting Started Webinar that is hosted on the first Tuesday of every month (the next one being on the 5th of March).
You can sign up using the link below:
There is also a free Tutorial and Certification for Xpress available online at the following address:
I hope this helps!
Thank you for your help,
I'll be in the seminar tomorrow. I'll check out that certification later this week.
Retrieving data ...