Can we round decimal points for angles as we do for other dimensions. I am talking about the bent angle. Please refer the attached image. Can I make the angles (38.27 and 37.73) 38 degrees but adjusting the number of decimal points ?
Sheet Metal Bend Note tolerances need changing in Document Properties > Tables > Bend
Vote for SPR 543625 if you want to control it in the same way as every other dimension.
For typical angle dimensions in a Drawing you'd set that by choosing the desired number of digits from the drop-down indicated below. I assume that's the same for sheet metal bend notes, but I'm not sure. If it doesn't work try making the same change in the Part's properties and then go back to the Drawing...or maybe one of the sheet metal gurus will respond.
Thanks, It worked
Retrieving data ...