3 Replies Latest reply on Feb 14, 2019 10:27 AM by Frederick Law

offset in mm but evaluate showing in imperial

Sean Birt Feb 14, 2019 4:11 AM

Good morning,

I have another issue. when offsetting a line in an assembly, i set the offset in mm but when it is complete it shows up as an imperial measurement. any ideas

Re: offset in mm but evaluate showing in imperial

Sean Birt Feb 14, 2019 4:35 AM (in response to Sean Birt)

hello again all this has started happening since the recent upgrade.
Like Show 0 Likes(0)

Actions
Re: offset in mm but evaluate showing in imperial

Glenn Schroeder Feb 14, 2019 10:23 AM (in response to Sean Birt)

See How do I change my units from inches to mm (or vice versa)?
Like Show 0 Likes(0)

Actions
Re: offset in mm but evaluate showing in imperial

Frederick Law Feb 14, 2019 10:27 AM (in response to Sean Birt)

If you could, type = before you enter dimension in mm. Like '=25mm'.
Like Show 0 Likes(0)

Actions

Go to original post