AnsweredAssumed Answered

what happens in SW non-linear simulation when calculated strain is greater than the "strain @ break" from tensile test

Question asked by Tianyuan Yang on Feb 13, 2019

Hello everyone, I just came up a question about what happens in the SW simulation non-linear analysis when Equivalent Strain goes over the tensile testing "stain @ break" value. I think that any result before strain reaches "strain @ break" value is referable but the one after is not as the result will be just interpolated?? Such as we can still check the respond plot through "Probe" up to the "strain @ break" for ultimate loads.

 

Please correct me if anyone has a better answer.

Outcomes