0 Replies Latest reply on Feb 14, 2019 4:36 PM by Michael Mottola

    IEC 60601-1 Test Finger

    Michael Mottola

      Are there any open source models of the IEC 60601-1 test finger? I have a drawing supplied by the standard but it would save me the time and hassle if there is one already. Thanks!

       

      Edit: Below is the "drawing" supplied. When i create a revolve of the bottom profile then a cut extrude of the top, it doesn't look exactly the same so I must be doing something wrong (I'm only concerned up to the first joint).