2 Replies Latest reply on Mar 24, 2009 7:05 PM by Duane Roberts

    hole table

    Duane Roberts
      is there a way i can manipulate the hole table to put a different size other than wht the model has. i have a model that usually gets machined i guess from end mills now it is being sent out to water jet and they dont hold the same tolrerances any ideas on what i can do?
        • hole table
          Eddie Cyganik

          Duane,

          You could manually add a column labled "Waterjet Tolerances" and list the applicable values.
            • hole table
              Duane Roberts
              THANKS I TRIED THAT IM JUST GOIGN TO HAVE TO ADD ANOTHER SHEET I DONT REALLY UNDERSTAND THE PHILOSOPHY OF ME HAVING TO MAKE TWO DIFFERENT MACHINE DRAWINGS FOR SHOPS BUT I GUESS. I DOTN UNDERSTAND I SUPPOSE ITS FASTER AND CHEAPER THATS NOT MY THING BUT THEY SEND IT OUT TO WATER JET THEN GET IT BACK AND HAVE IT COUNTER SUNK HERE AND PEMS PRESSED THREW. THE TOLERANCE ON THE PART WORKS IF YOU MACHINE IT WITH ENDMILLS BUT NOT IF YOU WATER JET OH WELL ON WITH WORK. THIS IS ANOTHER FINE MESS THAT I HAVE GOTTEN MYSELF INTO, BUT IF ANY CAN EXPLAIN ABOUT THESE PROCESS AND GIVE ME AN EXAMPLE GREATLY WELCOMED