AnsweredAssumed Answered

When I open parts the view is looking at the origin instead of at the part

Question asked by Rob McCune on Feb 7, 2019

Normally I hit isometric view just before I save so the view when I open a part is going to be an isometric view of the full part. Most of our parts are not located on the origin but where they would actually be located on the airframe of an aircraft due to the need to match the mold line in a certain area.  I just installed 2019 and all of a sudden the view does not focus on the part when I open, it is now a trimetric view at the origin. A related problem is that when I hit one of the view buttons (top, front, right) the view orientation will change to the correct orientation but I will either be looking at the origin or a zoomed out view including the part and the origin.  Anyone else having this problem?

Outcomes