What issue you're facing or what you've tried so far for converting them?
When i complete the solid to sheet metal , feature is shown in feature tree . But when i put the flatten command it is show the error like this
Please , Can you clear the problem ?
Vijay,,, What version of SW are you using? (if you want my file)...
First I healed the Face.
Then edited the inside and outside radii on four bends in order to get that in the feature tree.
Then delete the radii from the tree.. You will end up with sharp corners.
Then do an insert bends (or Convert to Sheet Metal) and set your information for material thickness, bend radius, bend allowance etc..
I'm using 2009 version solidworks
On the D002 I didn't have to square off the corners (delete the radii.. Just heal the face then edit the four radii. You can see why this is necessary in the following screen shot.
2018 Version attached.
I did ,
Please send asap .
Similar to Dennis's method I used Delete Face to remove the 6 radii and 2 non tangential faces (8 faces deleted).
Retrieving data ...