AnsweredAssumed Answered

Are Magnetic Mates of parts with configurations possible?

Question asked by Peter Klemm on Jan 17, 2019

Is it possible to define the magnetic mates for parts that have configurations in SW2017? I would like to assemble profile-bars with angled cutted ends together. The bars are always the same part but the cutting angle of the end faces are defined by configurations:2019-01-17 21_06_49-SOLIDWORKS 2017 x64-Edition - [Baugruppe1 _].png

For example: The picture shows 3 configurations of the same part in an assambly. By inserting a new one, the alignment should be on the base plane and then face by face.

I always get error messages because I cannot find a way to define the mating conditions with regard to the configuration settings.

Outcomes