All my macro's were a bit disorganised. As time allows I'm working through them and posting up anything that may be useful.
I'd welcome any suggestions and feedback.
I'm really enjoying learning the API. I hope you find something you like
Here's what I have so far.. (it will take me a while)
Parts and Assemblies
Toggle 'Marked For Drawing' Macro
Delete Sketch Entities Smaller Than... Macro
Parts
Insert Part Configurations Macro
Assemblies
Insert Multiple Virtual Parts Macro (with key detection on startup)
1 to 1 Assembly Configuration Macro
Drawings
Make Table From Sheet Names Macro
Other
Knowledge is gold .
Thank you for sharing.
I added to my favorites, I follow.
We are very "fortunate" because you are not a programmer.
programmers do not share this information. (the exception proves the rule)
Edit:
By the way! When you publish macros, it's perfect if you add a few screenshots.