17 Replies Latest reply on Dec 17, 2018 6:33 PM by Richard Ahlgrim

    Can I do this in Sheet Metal

    Richard Ahlgrim

      I'll preface this by saying this is my first attempt at using sheet metal other than the tutorial that comes with SW.

      I've managed to create this part easily enough but I need to take it one step further.

      Grider 2.JPG

      I need to bend or roll this part so that the final product looks like this.

      Girder 1.JPG

      Is this possible in sheet metal?

      If so, can you point me in the right direction?

       

      Thanks in advance.