1 Reply Latest reply on Dec 17, 2018 9:36 AM by Mike Loftus

    How to change filename of DriveWorksXpress output files

    Kray Shivers

      Hello All,

       

      I am new to DriveWorksXpress so bare with my through this question.

      The model i am using to start the data base is named JJ-000-000, this is our specific numbering system for assemblies and that type of name is what the output file should look like. So during my test i created a field in to form call "Item Number" and input the value "XX-001-001". through all of the rules i set up the group of files should have been named the following.

      XX-001-001_TQA

      XX-001-001

      XX-001-001a

      XX-001-001b

      XX-001-001c

       

      But what i get is JJ-000-000XX-001-001. with in the filename rules how do i delete the master filename and replace it with the item number as the file name?

        • Re: How to change filename of DriveWorksXpress output files
          Mike Loftus

          Hi Kray.

          In answer to your question about deleting the Master Model name out of the file name in DriveWorksXpress, the way to do this is to add "*" to your file name rules.
          I think in your case this would be = "*" & "Item Number"

          In the enclosed images i wanted my file name to be Order Number-Customer, where both values are an input on my form. My Master Model is called Magazine Rack.
          My file name rule is:
          ="*" &OrderNumber & "-" & Customer

           

          Hope this helps.

          Regards.

          Mike.

           

          DWXpress Rule.jpg

          DWXpress Form.jpgDWXpress File.jpg