Hi, I'm trying to use Loft\boundary on a complicated geometry and I can't do it.
i need to fill this geometry:(a planes tail)
and whenever i try this happens:
what can i do?
Welcome to the forum. As Maha Nadarasa indicated, it will be much easier for someone to help if you can post the file here. See FAQs (Frequently Asked Questions) if you aren't familiar with the process.
I'll just make a WAG and say you need more guide curves. For better help, see above regarding attaching a file.
To start, I would remove the cutout for the rudder fin and create the whole tail as one item. Then I would cut the fin out of the solid and shape it accordingly.
To get the shape correct, I would almost invert your selections and make the start/end points the front and the rear of the tail fin. The guide curves would need to be the top and bottom of the fin as well.
As Greg said, you need more guide curves to tell the boundary tool how the sides of the wing need to be shaped.
As everyone else has already brought up, you'll get a lot more help if you attach the file.
thank you for your answer, how can i attach the file?
How can I attach a file to a forum post?
It is a self-explanatory. In addition to that as follows:
FAQs (Frequently Asked Questions)
Retrieving data ...