I have been struggling with this for the last week. In my solid model I have two configurations. When I go to my drawing the routing doesn't update based on the configurations the drawing views are in. The routing stays in whatever view my solid model was in when I last saved. I made sure that my mates are all updating based only on the configuration they are placed. I contacted our sw support and they told me to try using spools, and that they "rarely mess with routing". They however gave no advice on how to use spools and I have found nothing on using spools for electrical routing on here or on the youtube. If anyone could help me out with this that would be great. I wish I could share the part but I signed a NDA so I can not.