1 Reply Latest reply on Dec 3, 2018 4:08 PM by Jeremy Feist

    Flex tool for bending small extrusion in part

    Uchenna Offor

      Hello all,

       

      I am trying to use the flex tool to bend a small extrusion in a part around 20 degrees.

      The problem is the closest I've gotten to with the flex tool is that it bends above the red line instead of below. I haven't dealt with the flex tool fully before so this is my first time using it. Any ideas? I've attached the file.

       

      Edit: I know there are other ways to do this, but I want to learn the flex tool to expand my SW knowledge.