currently i just fake it creating a square bar sheet metal part and put fillets on the part to get it to look like round bar, then create configurations for the drawing...
currently i just fake it creating a square bar sheet metal part and put fillets on the part to get it to look like round bar, then create configurations for the drawing...
Here is some reading material:
The 3rd Weekly Power-User Challenge (May 5th, 2017): Bend a square profile in multiple directions and determine its flat pattern
https://www.engineersrule.com/impossible-modeling-challenges-part-3-un-bend-square-profile-multiple-directions/#_ga=2.25…
The 4th Weekly Power-User Challenge (May 12th, 2017): Unbend a Bent I-Beam
The 5th Weekly Power-User Challenge (May 19th, 2017): Straighten an Imported Wire
https://www.engineersrule.com/impossible-modeling-challenges-part-2-dynamic-straightening-bent-wire-cad/#_ga=2.96461404.…