AnsweredAssumed Answered

advice on sketch driven fasteners

Question asked by Varun Sharma on Nov 27, 2018
Latest reply on Nov 27, 2018 by Varun Sharma

hi guys, so I am having a small issue with sketch driven fasteners. I am able to save time and copy my fastener subassembly to the other mounting holes where I need them to be but they are not completely copying as they should. the image below shows what is going on. I basically make my point sketch right in the middle of the orange mounting holes but when I do the sketch driven fastener it copies the subassembly as shown?

 

The red arrow points to the correct orientation of how I want the fasteners to look and the fastener to the right is what results after I do the pattern.

 

(ignore the extra hole next to the patterned fastener because there are 2 holes back there and it aligns concentric with the hole but is not placed as it should)

 

Outcomes