I need to add mates to confine a pipe/tube between two holes - as if it is being held by a u-bolt. What is the best mate technique to do this?
2 ways that I can think of that will work:
Dan's second option worked the best for me - I just wish there was an easier, more straight forward, way to do it.
Thank you Dan
My recommendation would be to turn on centerlines (view>show>alt axis - something like that) and then set up constraints to the C/L of the pipe to the U-bolt side C/L and back to the clamp bar if there is one. It will still be able to rotate but that may not be an issue. No extra geometry required.
Retrieving data ...