2 Replies Latest reply on Nov 26, 2018 3:32 PM by Robert Gaynor

    Lofted Surface problem

    Robert Gaynor

      Okay so I'm modelling a toy quadcopter I bought for a school project, and it's a pretty complex shape so this is all unknown territory to me.

      Here's the quadcopter:

      IMG_1225.JPG?width=606&height=611

      IMG_1226.JPG

      This is what I've modelled so far:

      unknown.png

      This bit at the back is what's causing trouble for me:

      unknown.png?width=692&height=610

      I kinda expected this, but when I loft between A and B, it fails once I add in guide curve 4 (I'm guessing because it doesn't go all the way from A to B. However if I were to continue that guide curve along fully, it would be identical to guide curve 3 from that point on.

       

      unknown.png

       

      Any suggestions?