One of our drawing checkers is trying to make use of the Design Checker tool in SW 2008 SP5.0. He setup the criteria and when attempting to perform a check on a drawing the Task Pane tab for DC comes in blank and the graphics for it arent refreshing. So whatever was displayed previously; i.e. the SolidWorks Resources tab or any other, is displayed in the DC tab. If I switch to a different tab and then try to activate the DC tab the graphics still do not refresh. Same goes with minimizing the Task Pane and then bringing it back out.

Has anybody else seen this behavior? I was originally leaning towards the graphics card/driver but everything else works just fine, it seems as if the tool is hanging up.