What heading do I use in a design table to allow the sheet metal gauge to be edited?
Double click the "Sheet Metal" icon in the tree. It should now show a few dimensions on the part in blue. Right click the dimension for "thickness" and click "configure dimension". This will not work if you are using a gauge table.
What you are saying will not work is what I was asking for. How do I control the gauge of a piece of sheet metal using a configuration table.
The flip side to this is how do I get a bend radius into a table directly if I can't get at the gauge. Going into this even more, how can I get a bend radius into a design table if the part does not have a bend or is not using the gauge table.
I did a little looking around and I'm not sure it is possible to change this from a configuration when using a gauge table. Let's see if someone else chimes in on this.
Retrieving data ...