I tried to trim the spoon surface ,select sketch 1 in trim tool though the piceces to keep,I can't select any surface it showing error pls help.
Hello Anamika,.. looks like the sketch was not closed ..see images attached..
Just a quick initial guess here but it might have something to do with the fact that your sketch is exactly coincidental with the surface at the spoon tip end. Maybe it's sensing something there?
It's a lot easier for folks here to help with issues if you attach your part to the thread and that way we can all look at everything involved that may be causing you problems.
Thanks a lot for your quick reply .
Actuallyu I am kind a new in the world of solidworks,so it's bit tough for me to explain the problem in exact way ,Pls excuss me.
And pls find the attachment of the model and suggest me the correct.
and "I want to trim the below surface w.r.t the sketch."
Thanks in advance.
Thanks @paul salvador
I found the area and made the correction and now everything is good to go.
Thanks again for your help...
have a great time.
PFA of the part I made.
Ensure the sketch is within the boundaries of the Surface not tangent. Should work then.
Thanks for reply.
Sketch is within the boundaries of the Surface and it is not tangent.
Any chance of posting an image from above? Is your sketch a closed loop?
Problem has been solved.
Your sketch has a self intersecting contour. You can use Check Sketch for Feature which will tell you. I've highlighted your problem area.
I'd also work on fully defining your sketches.
Thanks Kyle ,
PFA of the part.
Retrieving data ...