using an assembly to run flow simulation, but also continuing to conduct design work on parts. is there a way to separate the functions with the same assembly, so that it does not try to start the thermal when the assembly is opened?
You have to have a model open w/ a Simulation case in it so that the Simulation tab shows up. Then go to that menu item and select Options.
I think you have to set your options to not load the FEA when you open the model.
Edit: Maybe this:
Thank you, James. I took a look through options and didn't find the command. Do you happen to know the path to where you can not load the FEA?
Ok, I found it. I was looking at the options in the tools menu, but found it looking for the options in the simulation menu.
Thanks for the reply .. very appreciated!
Retrieving data ...