Is that what you're talking about?
It is just sample for you.
You can do the same.
Thanks for that a lot.can it be done just with the swept boss option?
I am not looking for the complete model.what you have done initially with the loft can it be done with swept boss?
In your model is the bottom face absolutely flat?
I don't know, but I think it will be difficult.
there is unusual bump in your model in the cross-section.It does not match the cross section B-B.
I do not have much time. Therefore I quickly drew the sketch.
You can take the time and edit it.
Add new path to loft. If you edit the dimensions, it will be more accurate.
Thanks Omur for your help.
I can make is model correct with Swept boss with cross-section at the end of the guide curve.
was just looking for a better way with cross-section in between.I thought the new bidirectional option would be an help but no it was of no help.
You can extrude the base with 5° draft. And then boundary surface to create the top side. Loft cut for the front end cut, add fillet and shell. Add the bottom cut and finally the screw boss at back with hole.
Thanks a lot Deepak.
how to get that dimension of 30?
as it is not on section B-B.
You'll have to manipulate the dimension at section A-A to get the desired value of 30 as shown in section A-A.
Thanks again Deepak
Retrieving data ...