2 Replies Latest reply on Nov 8, 2018 9:08 AM by Shawn Stugard

    Changing Smart Dimension Settings

    Mark Williams

      Hello,

       

      I'm editing a part that I did not create and I've found that there is a thin "8" placed at the beginning and end of the dimension in a sketch I'm creating within the part (see attached picture). Is this due to a setting within SolidWorks that I might not be aware of, or is it simply a bug? I've done some searching in the System Options and Document Properties, but haven't found anything for this particular situation. The dimensions are set to two decimal (0.12) for this part, so the fact that it shows up as 0.04 instead of 0.035 makes sense, but I've never seen the "8"s at the beginning and end of the dimension.

       

      Thanks,

       

      Mark

      Dimension8s.PNG