Hello friendsPlease help me out in the picture below how to do this parallel plan operation
I'd better explain that I want to use the cnc tool path on the workpiece so that the tool is displayed without a spin and gradient in the piece file. Thank you for helping friends.
The sweep path sketch should be made parallel to the surface desired, prior to sweeping. Or, you can edit the path sketch after sweep creation.
Thank you for the advice. But my friend may have been poorly explained. I mean, I want to high up in the tip of my triangle in the sweeped path, until the end of the path and path is like a car hose that can not be parallel to the end of the page.
Someone can help me figure out how to face that I showed in the image until the parallel sweep ends of the plan
Hello Reza,.. from what I see and have played with,.. you are not going to get SolidWorks to Sweep this Normal To... you can extrude a surface normal to and it will give you a Ribbon... or representation of the direction.. from there, you can manually try to build geometry to represent the tool/path,.. as is, some paths are sharp and to steep.. I had more time maybe,. but.. I'll attach what I saw/found or what I think you maybe wanting (showing ruled surfaces) or pattern how the tool would step along this path (which I would use for the cnc cutter path)?
Thanks for helping meIn fact, I want to design a control fixture for a hose so that the hose path is on a block cnc and give the block 3dfile to the cnc but when I want to cut the hub or the 3d sketch path, some parts of the slope 3dsketch path And it's angled that I can not specify the correct path to the cnc tool on the block , Excuse me that my English is so bad and I can not understand what I mean
Retrieving data ...