I'm trying to change the Archive Configuration of this part so that when you click on it the Description field shows. Right now it is set to a 200 sets config and i want it to point to the assembly definition. How do I go about changing this?
Have you tried un-checking this? I'm assuming you want the @ tab shown at all times. It's not really possible to change the active configuration to @ since it doesn't really exist outside of PDM.
The 'active' configuration in which PDM defaults to without changing that Display option is usually the one that was active when the file was last saved/checked in.
While I definitely prefer the solution above, you could theoretically check out the file, activate the desired configuration, save it, and check it back in. It should work but I think that's way too much effort than the above solution.
Retrieving data ...