Hello that such all!.
I have a recurring error in my software because whenever I want to convert a solid to sheet metal and choose the first fold the program closes (or locks). It always does and it's a mistake that annoys me too much. I do not know that this happening hopefully someone can help me.
Que haces Ricardo....estaria bueno que adjuntes el archivo o nos envies alguna captura para poder ver in situ que sucede con el mismo...
Make sure you have tangency from flat section into bend.
Tangency is required for sheet metal.
Check your model before the conversion to sheet metal.
You don't need tangency to convert to sheet metal. The conversion usually happens.
But a lack of tangency may cause problems after conversion.
As others have stated, please post some screen shots, including images of the feature tree so we can see your workflow.
Even better, please upload your files if permitted.
Click "Use advanced editor" in the upper right:
Then click "Attach" in the lower right corner: