Further in depth: I was wondering what command would one use to create a pattern that is staggered with a part in an assembly. (Tiles)
Thank you for your help.
Try a component pattern. There are several types... Linear, circular, curve driven, table driven, etc... The best one to use depends on what your pattern is. To help any more than this, you will have to tell us what your pattern is. And not just "staggered". Post a pic, a drawing, a link, something.
Thank you for your quick response but I was able to come up with a solution. My solution which is maybe not the most efficient was to just make an assembly of the pattern using the part in question and then pattern that on the assembly I needed the pattern on.
Again Thank you.
Retrieving data ...