4 Replies Latest reply on Oct 31, 2018 1:09 AM by Alexander Madonna

    Incompatible meshes using the same settings?

    Alexander Madonna

      Hi There,

       

      I'm doing a few pressure vessel combined studies and I am getting a problem.

       

      I've run regular studies without any issues at all using the same settings (I've attached the part for you to have a look at), however the meshes come out differently. I have no idea why this would be the case considering all of the fixtures and component contacts are the same for each of the static studies and the forces are all applied in the same way. Some of the studies come out with the same mesh and some do not.

       

      There are two photos from two static studies showing the differences between the meshes causing the inconsistencies.

       

      Any help as to why this would be happening would be greatly appreciated!

       

      Thanks,