AnsweredAssumed Answered

why do my BOMs populate differently between my assembly and my drawing

Question asked by Shane Kozlowski on Oct 23, 2018
Latest reply on Oct 24, 2018 by Shane Kozlowski

Below you will see exactly what is happening to me. My equation to populate the length of a bulk part (2.0) works fine in the part, and in the assembly. When I put this same equation into a drawing I get a completely different value (50.8) and I don't even know where it came from.

 

1) Why would this assembly and its drawing give me two different results?

2) If #1 can't be answered, Is there a way to find the origin of the computed value for a BOM cell so I can trace back to this odd number showing up?

Screenshot (11).png

Screenshot (14).png

Outcomes