6 Replies Latest reply on Oct 18, 2018 11:44 AM by Sjoerd van De Velde

    Project sketch on surface

    Sjoerd van De Velde

      Hello,

       

      I'm trying to create a 3D sketch that I later want to use for a sweep path. For now I kind of get stuck in finding an easy way to define the start and end points of said sweep paths. I want to have 6 points on the dome surface, but I can't seem to figure out how to place them there. I can't project the sketch because it's open profiles, I can't derive sketch for the same reason.

       

      What I did before is projecting a circle and the 3 center lines to the surface and placing a point in the intersections, but that is very time consuming and gets harder as my "points sketch" gets more complex. I feel like there should be a very simple solution to this problem...

       

       

      Kind regards,

      Sjoerd