2 Replies Latest reply on Oct 15, 2018 8:31 AM by Kevin Chandler

    Assign a layer to Annotations

    Sergio Monti

      Hi all, do you know whether is possible to assign a default layer to the following:

      - Dowel Pin Symbol

      - Caterpillar

      - End Treatment

      I know there is a similar thread for revision symbol and the relevant SPR 667028 I already voted for.

      I actually would like to assign to Dowel Pin Symbol the same layer of centrelines (or whatever different) and assign to Caterpillar and End Treatment the same layer of Weldings (or whatever different).

      I'm still on SW2015 so I would like to find out if the functionalities I'm looking for have been already implemented.

      Thanks