2 Replies Latest reply on Oct 15, 2018 5:31 PM by Bill McEachern

    Comparing two different stress plot models

    Marlene Wartenberg

      Hello,

       

      I built two different wedge system models, varying only by a slight difference in the angle of the wedges, and ran a static test to obtain the stress plots. I want to compare the stresses by fitting the colored data bars to take into consideration both stress plots. Below are images of the stress plots of both models, in which I would like their data bars to match:

       

      pen_4 section.PNG

      pen_4 section.PNG

       

       

      Can this be done in Solidworks 2018, and how? I attached the two models and parts. Any help is greatly appreciated.