I am new in sw, so, is there design accelerator for shafts like in inventor?
I am new in sw, so, is there design accelerator for shafts like in inventor?
I see how works this one....but it a little bit complicated, draw it and add a design table if you needed.
Aula Inventor - Design Accelerator 01 - Shaft (Eixo) - YouTube
I design a complete die spring if you needed (by design table) . It's easy peasy...but here a buddy made a program to design automatically springs.
Complete die STD - ISO-10243 (load and unload by colour too) by myself (made on SW2016SP4)
CvC Tools - Rev. E-01 Courtesy of Christian Chu
Not sure about design accelerator feature of Inventor but check the toolbox utilities: