AnsweredAssumed Answered

is there a way to sketch on a part in assembly so that sketch can be visible in the part file?

Question asked by Varun Sharma on Oct 9, 2018
Latest reply on Oct 10, 2018 by Glenn Schroeder

I want to basically draw reference holes on a panel where I need to make cut outs. I was able to draw where these holes should be in my assembly but not sure why those sketched holes wont show up in the individual part file as well. Is there a way to do this? I know when I make sketches in the individual part file those sketches always appear in the assembly but I need to go the opposite to properly draw the reference sketch on where I need my cutouts to be.