2 Replies Latest reply on Oct 5, 2018 7:59 AM by Andrew Kamp

    Parting Surface Problem

    Andrew Kamp
    Andrew Kamp Oct 4, 2018 3:46 PM

      Hi all,

       

      I am trying to create a two piece mold for the attached part.

      I've already created a closed off surface for the hole down the middle (I think it will work this way), but when trying to create a parting surface, Solidworks fails due to "a geometric constraint".

       

      Capture.PNG

       

      Any ideas as to what is going wrong, or any advice on how to create this mold?

       

      Thanks!