AnsweredAssumed Answered

Simulation - Bolt connector parameters

Question asked by Dawid Cebularz on Oct 4, 2018
Latest reply on Oct 5, 2018 by Mohamed El Orche
  • Comment • 1

Hello

 

Perhaps a silly question from me:

As per attached picture, lets say we use M8 coarse thead pitch, is threads/mm value actually threads/mm (1/pitch = 0.8) or is it bolt pitch value (1.25)?

I have seen in many videos people using pitch value that`s why I am a little bit confused.

Mohamed El Orche
Mohamed El Orche Oct 5, 2018 4:56 PM
Correct Answer

Hi Dawid,

 

It is Threads/mm value.

Thread.jpg

check out this  2018 SOLIDWORKS Help - Connector - Bolt

 

Hope this helps.

Mohamed.

See the reply in context

Attachments

No one else had this question

Outcomes