Hi Salaheddine Laalmi ,
No need to start all over again.
You can use 1 set or 2 sets of breaking lines.
You can dimension to the centerline.
If the centerline is between the breaklines you can move (drag) a set of breaklines, and the centerline will appear (if it was applied earlier).
Hi,Salaheddine Laalmi ,
This probaply because the centerline is between the breaklines.
You can move both break lines by dragging them a little bit to the left- or right-side, until both are on the left or right side.
No you can get that shown unless you move the break view to side and expose the center area. May be add two break views; one on each side.
Mr Deepak Gupta , Henk Bruijn De
yes the break view is in the center and the part is too long to do that i tried to make two break views but unfortunately it will get all my dimension and i must recreate th drawing from zero thats why i am avoiding it and i did draw a center line but it wouldn't have dimension with the parts in the drawing
You can keep only one break and you do not need to create it but you can drag it to the side so that center is exposed.
Retrieving data ...