4 Replies Latest reply on Oct 9, 2018 11:34 AM by Bruce Harter

    Hatch pattern on sections appears after save

    Robert Pickeral

      I'm the admin. I'm having engineers describe to me that on a model driven drawing; in a section (with no hatch pattern displayed), hatch patterns are appearing after a save and reopen. And the hatch pattern itself is misaligned. It's not "within the lines" - where they should be. I wish I had more detail, but that's all I know at this point. This was happening with Solidworks 2017 SP4 and is happening with 2018 SP4 as well.

       

      Is there any reports of weird hatching appearing after a save/reopen? Any suggestions would be appreciated. Thank you.