I use cut-sweep, you can see the following pictures.
My design is to insert a pin to the curve
I want to "rectangle" follow the curve and do not twist
I see the setting of twist in cut-sweep. but I cannot set it right.
use the direction vector option - selecting either the cylinder face, or the flat face (or a plane) perpendicular to the cylinder.
I followed your advice, but still not work. It still twist
your front plane is NOT perpendicular to the cylinder.
OK. I create a plane5, this is perpendicular to the cylinder, but still not work
nope - that is still not perpendicular.
How's about using wrap feature ?
Hello Jason,.. the profile should only have a "Pierce" relation on your Path.. and the Sweep the default Follow.
The plane you are sketching the rectangle on needs to be perpendicular to your guide path spline at the endpoint of the spline. The 'follow path' sweep maintains the cross section perpendicular in rela tionto the path by default. If your cross section is not pependicular to the path, whatever angle it makes with it will be maintained through the path. Make sure to relate a point in your cross section sketch to be a pierce point to the path spline.
Retrieving data ...