I took your model and added relief in the corners. Also trimmed sides so they would not intersect themselves. I would have done it some what different but I used your current model.
housing1.SLDPRT.zip 215.4 KB
Awesome & thank you very much
Your file is a future version compared to my 2015 seat. Looking at your .jpg, the tab sticking out is too far. You need to trim that back to where you want the bend to start, and using the edge flange or the miter flange tool create it. You may need to insert little notches or "reliefs" so Solidworks can bend the sheetmetal like what would happen in a press brake.
Hope that helps. Learning along with you.
Hopefully Dennis Bacon sees this and schools both of us.