Hi guys I have this autocad drawing that I am trying to create a model for , I have attached my attempt and the DWG drawing. Any help in modeling would be greatly appreciated.
Is that what you're talking about?
Hi ömür, thanks for the reply/help. My problem is that I cannot get the model I make to look like the autocad drawing. The radius and contures seem wrong to me. Are you able to open the .dwg? If not I can attach a pdf.
I can take care of it in 5 hours.
18:30 turkey at the moment.
Hello Carlos,.. based on the DWG.. the bottom blend/radii is 4" (correction.. it's Variable,.. see below).. so, you'd need to increase the base sketch corners to a min of 4.. (I had to go to 4.25" to make it blend..
...I take that back.. it looks like it's a Variable Fillet R2-4"
Hi Paul Do you have the file , I try to do what you mention in your reply but I must be doing something wrong?
Hi Paul, That looks great , with the model I uploaded and I dont know if you would have the same problem with yours but , another issue I am having is that if you looks at the DWG I uploaded there is two clips. These two clips are supposed to go on the front of the try but it seems that that area is supposed to be flat but I can only get it to curve.
Retrieving data ...