When i try to use the mate controller for sub assemblies but i couldn't select the limit distance mates even thought i made that sub-assembly flexible.
PFA reference assembly.
thanks in advance
Niderhan, I have just found the same problem, in SW2018, SP5.
I had an assembly, inherited from another engineer, which included a nicely functioning mate controller.
I needed to divide it up into its appropriate sub-assemblies, whereupon there were, apparently, no valid mates for use by the controller.
That does make the whole Mate Controller pretty useless, in my opinion.
Are there any work-arounds that anyone is aware of?
<<Edit: I answered my own question. I didn't have enough sub-assemblies set to 'flexible'. One was, but its mirrored brother wasn't. Once I set them all to 'flexible', things started to behave as I hoped again.
Retrieving data ...