I'm modeling a Hyperbolic Worm Gears, but when it comes to converting into a solid tube. it appears all kinds of problems
I appreciate any advice
I was able to get a solid body, probably not in the most efficient way, but it seems to work! Take a look!
Here is another method using planar surfaces and trims...
Hello Victor,.. a workaround to just get all the Lofts to knit is,.. I'll call it a edge loosener, is doing a Split Line on one or more surfaces.. so, in this case... if I Split the Superficie-Recubrir10 surface,.. it Knits fine.
btw, I redid the lofts by piercing your sections to the 3D curves instead of the previous loft edges.. that is, using/maintaining the same parent references.
..and another way...
Thank you very much for the solution
I had been trying for a long time to understand how to join these surfaces
again a thousand thanks.
now I leave my contribution, the curves are made with mathematical equations.
without those joined surfaces I could not advance with the model
Retrieving data ...