I was recently tasked with modelling a bunch of wire connectors with wires that were to now route through a new loom/harness. I'm new to 3D sketching and eventually got it made, but I know there are better ways than tweak and rotate. As these connectors were at various different levels in the assy, corralling them into the same general path was none too easy.
Is there a good tutorial on freehand 3D sketching? The SWX tutorial on 3D sketches is okay, but only if you're working on/with planes and straight lines/small curves.
Thanks in advance y'all.
P.S. Whatever happened to Kelvin Lamport? He was great, and I learned a lot from him.