AnsweredAssumed Answered

part that fails to mesh

Question asked by Babis Lazaridis on Aug 28, 2018
Latest reply on Aug 29, 2018 by Babis Lazaridis

hi a have a part that was a parasolid that i saved as a solidworks part (i run imported diagnostics and i corrected some faces). i cut a piece of it using indent (or combine, i don't remember) and as a result i have some very small geometry in some places. i tried all meshing options and they either fail or they never complete (and my ram is constantly at 100%). i tried using mesh control but in mesh failure diagnostics it doesn't show specific edges and faces, but the whole part. any suggestions?